### 8. **Error E20: Overtemperature Fault**
- **Cause:** Excessive temperature detected in the machine components.
- **Solution:**
- Check for adequate cooling and ensure fans are working.
- Inspect ventilation for blockages and clean as needed.
- Allow the machine to cool down before resuming operation.

### 9. **Error E25: Communication Fault**
- **Cause:** Communication issue between the control panel and other machine components.
- **Solution:**
- Check all cable connections between the controller and components.
- Restart the machine to reset communication channels.
- Replace or repair damaged cables if needed.

### 10. **Error E30: Memory/Storage Failure**
- **Cause:** Issues with the machine’s internal memory or storage.
- **Solution:**
- Clear unnecessary files to free up storage.
- Reinstall software if corruption is suspected.
- Consult LVD support for assistance with memory-related issues.

Always consult the specific manual or documentation for your LVD bending machine model for precise troubleshooting steps, as error codes can vary by model.

### 4. **Error E07: Axis Limit Exceeded**
- **Cause:** Axis has moved beyond its programmed limit.
- **Solution:**
- Verify the programmed parameters and ensure they are within safe limits.
- Reinitialize or reset the axis to bring it back within the operational range.
- Check for encoder or sensor malfunctions.

### 5. **Error E09: Safety Circuit Activated**
- **Cause:** Safety devices like guards or emergency stops have been activated.
- **Solution:**
- Inspect all safety devices and reset any that have been triggered.
- Check for any obstructions around the safety guards.
- Verify the integrity of the safety circuits.

### 6. **Error E12: Control System Error**
- **Cause:** Problem with the main control system.
- **Solution:**
- Restart the control system.
- Update the software or reflash if the error persists.
- Contact LVD support for further diagnostics if necessary.

### 7. **Error E15: Calibration Error**
- **Cause:** Misalignment or calibration issue with one of the axes.
- **Solution:**
- Run the calibration procedure as recommended by LVD.
- Inspect sensors and encoders on the affected axis.
- Ensure the machine is set up on a stable, level surface.

LVD bending machines typically have a variety of error codes that may appear due to issues in the hydraulic, electrical, or software systems. Here’s a list of common error codes and solutions:

### 1. **Error E01: Hydraulic Pressure Failure**
- **Cause:** Insufficient hydraulic pressure.
- **Solution:**
- Check the hydraulic oil level and refill if low.
- Inspect for any leaks in the hydraulic lines.
- Ensure all connections are secure, and the hydraulic pump is functioning correctly.

### 2. **Error E02: Motor Overload**
- **Cause:** Motor overload due to excessive load or obstruction.
- **Solution:**
- Verify the load and ensure it’s within the machine’s capacity.
- Check for obstructions or mechanical resistance in the system.
- Allow the motor to cool down before restarting.

### 3. **Error E05: Backgauge Malfunction**
- **Cause:** The backgauge is not responding or is misaligned.
- **Solution:**
- Inspect the backgauge alignment and recalibrate if necessary.
- Check the backgauge motor and connections for issues.
- Clear any debris or obstacles that may be blocking movement.